• Easy to service pump base
• Machine functions controlled by proven relay logic technology which allows for easy in the field troubleshooting and low cost repairs: No printed circuit control boards!
• High efficiency mass style heaters
• Improved heated hose assemblies
• Innovative TSU designed for clean, inexpensive on the job replacement

Ideally suited for pumping Prime Resins line of polyurethane foam or polyurea coatings

Applications include “Precision Lift” raising sunken concrete slabs, void fill and soil stabilization. This machine is also suitable for spray foam insulation applications

"Turn key" spray rigs are available!

• Simple, yet powerful air operated unit featuring consistent air pressure
• 5" air motor with instantaneous reversing delivers uniform mixing pressure, 1760 PSI max output
• Efficient, consistent, operation
• No electricity required

Ideally suited for pumping Prime Resins line of urethane joint sealers and dual-component polyurethane resins

Can be used to pump any of the Prime-Flex products

• Our most powerful and most versatile multi-ratio, air-operated unit.
• It consists of two Graco Monark pumps that operate independently of each other.
• 600 psi output pressure.

Ideally suited for pumping Prime-Flex Hydro Gel SX or Prime-Flex 900 XLV at variable ratios with water.

Can be used to pump any of the Prime-Flex products as a single component material.

• Features a hydraulic drive powered from either a gas or electric power source
• 400-3300 psi output pressure
• Features heavy duty frame designed for one-man loading and unloading for vehicle

High production pump for injecting any of the Prime-Flex products as a single component material

Ideal for use where extra long hose lengths are required or for deep soil grouting where sustained high pressure is required

• Small, lightweight, 7/8 HP Unitec electric pump
• 0-3200 psi output pressure

For use on light duty applications only

Delivers any of the Prime-Flex products as a single component material

• Mounted on steel frame.
• Built-in check valves.
• Volume per stroke: 1.18 cubic inches.
  Maximum pressure: 2500 psi.

NOTE: NOT FOR USE WITH EPOXY TYPE RESINS.

Designed for pumping low viscosity single component material such as Prime-Flex 900 XLV, Prime-Flex 910 or Prime-Flex 920

Pumps Prime-Flex Hydro Gel SX as a single component material

Ideal for use as a water pump to flush cracks prior to injection.

Use with polyurethane resins while controlling active leaks in concrete

Available in stainless steel or brass (for low pressure only).

Designed to mix water and chemical grout at point of injection.