- blank
- Product
- Description
- TDS
- Brochure
- SDS
Products
Description
Acrylate, very low viscosity, low toxicity, elastomeric gel, NSF/ANSI 61.5 certified for potable water use, primarily for geotechnical applications
Description
Two-component, low exotherm, polyurethane foam used to fill voids and underseal concrete slabs. Its low viscosity allows for moderate permeation effects as well. The resin produces a closed cell, high density structural polyurethane foam.
Description
Two-component, closed cell, hydro insensitive, high density structural foam. Density 3.8-4.2 lbs./ft³. For undersealing, stabilizing and lifting concrete slabs. Used for compaction grouting and filling small voids behind pipes, walls, manholes, etc.
Description
Two-component, closed cell hydro insensitive high density structural polyurethane foam. Density 4.5-5.0lbs./ft³. For undersealing, stabilizing and lifting concrete slabs. Used for compaction grouting and filling small voids behind pipes, walls, manholes, etc.
Description
Hydrophobic single-component polyurethane, super low viscosity, water-activated to form a rock hard, watertight mass. requires catalyst.
Description
Hydrophobic, low viscosity, highly expansive, water activated polyurethane. Forms a watertight, rigid foam. Meets NSF/ANSI Standard 61 for potable water contact. Requires catalyst.
Description
Two-component, hydrophobic polyurethane expansive foam to fill voids, stabilize soil, underseal concrete slabs. Low viscosity allows for moderate permeation effects as well. Available in 985 LX10 Fast when a very rapid reaction time is required (18 seconds).
Description
Two-component, low exotherm, polyurethane foam used to fill voids, stabilize soil and underseal concrete slabs. Its low viscosity allows for moderate permeation effects as well. Independently tested and verified to meet NSF/ANSI Standard 61.5 for contact with potable water. 985 LX20 Fast has the same features but with much faster reaction times.
Description
Low viscosity, single-component, water-activated, multi-ratio hydrophilic gel/foam polyurethane. Meets NSF/ANSI Standard 61 for potable water contact.
Description
A soil binding system that adheres to, and binds fine silts, sands, pebbles, gravel, stones and rocks into a single cohesive mass. Can be used to treat loose, poorly compacted soils and organics prior to trenching, boring and excavation. It can prevent further erosion and weakening due to water penetration. SoiLok is a two component, 1:1 ratio system that will gel and cure with or without the presence of moisture. Gel times can be adjusted to address the unique soil conditions that exist to provide optimum results.
Description
The DPM30 penetrometer allows exclusively continuous dynamic penetrometric tests to be performed. For the dynamic tests, the penetrometer is equipped with a 66 pound (30 kg) hammer with a 7.87 inch (200 mm) stroke, operated by a hydraulic motor. It is driven by a motor-pump unit, where the motor can be either electric (220v or 110v) or a petrol engine. A hydraulic extractor is used to extract rods, lining tubes and samplers. The penetrometer is controlled via a pedal-operated distributor. The hydraulic connections on the various components use quick connectors.
Description
Prime Flex SWF is a two-component polyurethane injection resin used to fill voids, stabilize soils and seal defects behind sea-walls. The slow set time combined with the guaranteed reaction of a two-component system allows the resin to penetrate the soils thoroughly, greatly reducing chances of unreacted ‘pockets’ of material.